Recent content by sabooo

I'm just southwest of Allentown, not far from I-78. The drive to anywhere is Hunterdon Co. is not bad at all for me. My skill at circuits is just above zero, and my concern is just how intolerant small electronics are with mistakes :) Would hate to fry it before I get to try it.

The ground station doesn't give me any stress at all, but figuring out the cameras -> Video source switch -> OSD -> vTx has me shaking my head. :) You're exactly right about the connectors. I'm thinking I'll have to sit down and map it out and then figure out how to get it all tied together...

So I purchased what I believe to be a complete FPV setup from Readymade RC to use on my F550 - 1300MHz vtx (yes, before you ask - KC3CST :) ) Skylark Tiny OSD w/ GPS (realized this is 5v - I believe I have a small BEC around) FPV CCD Camera RC Video Switch GoPro camera & Cable (hoping to setup...

Thanks Ed! I appreciate the response. - I wasn't sure if numbers closer to the midpoint of what the literature claimed as acceptable was better, or if my results might indicate something was amiss with my setup. I did enjoy a full flight yesterday and had no issues in GPS mode.

Hi all! I'm new to multi's and naza, so I'm trying to second guess everything I do. I just finished a F550 build using the standard combo kit and a nazav2. My first two mod values are spot on, but my compass mod is up around 1900. Is this normal / ok? Should I try calibrating again...

Yep, I think I paid for a big chunk of Rick's kids Christmas presents this year :) I know I can get things cheaper via mail order, but I try to support the shop as much as I can. What part of NJ are you in? (Or is the correct question "what exit?" :) ) Thanks for the warm welcome!

Thanks to everyone for giving me quite a bit of good reading! I'm just starting to dabble in multi's. My experience has been an on and off love affair with RC Heli's. After a 10 year hiatus, I got back into electric heli flying about a year ago. I always wanted to do aerial photography with...