Recent content by rsc

also interested!

Is it possible to power the servos from the receiver (red and black) and take the signal wire from the Naza?

We have Pan stab working.. However we want the ability to turn the stab off for the same reasons. I have made the lead and can turn the pan off and/gimbal off. But is there a way just to turn the pan stab off so you can still operate the pan manually? Firmware much better.. Regards Rob

Umm... no we have not! Still a useless pile of Sh... untill photohigher update there website with relevant instruction/recall.

Totally agree.

Not such a stupid idea, although import/export and cost of shipping is so high! might be easier to get them to send me the cell! I think your right, the cell is clearly breached. I have emailed Maxamps for help. Thanks to all

close up

Thanks for that, not smelt anything and its been lying around (in an ammo box) for over a week now!

I have a very expensive maxamps 110000mha battery that has just taken a beating on an unscheduled landing... it has a a dent and has penetrated the outer covering. I have tested the battery all cells are fine and its not leaking. it also charges fine. This battery was seriously expensive and i...

I have spent the morning making up the H lead and testing... I have lost 70% of the jitter WAHOOOOOOO!!! However there is still a little which i hope the new firmware will remove... Its getting there.

Well i have pulled the wiring apart, tried the separate powering and no difference. I get constant jitter on the roll, not the tilt. However i can eliminate the jitter by unplugging the tilt servo!! I have checked the wiring loom although not perfect its serviceable. I have tried Torrids on the...

A little oscilation in the wind... few more settings to tinker with... gimbal on... SORTED!:tennis:

ITS FIXED..... Cant belive it.. i spotted the 2 plugs in the wrong place 2 days ago, i must of plugged them straight back in to the same ports... So the moral of the story... check, check and check again! Thanks for all your support guys, which is far more than i got from the UK seller...

You know when you have checked wiring again and again!! 7 and 8 plugged into wrong port, i hope this sorts it... testing in a min!