Recent content by robyr1

I updated the firmware on Master imu, and if i try to update the Slave i'm unable because when i power on the fc don't update it automatically like i do it for the Master...any suggest? my seller says wich is normal, the slave don't need to be upgraded

Right..so we should to wait

ok thanks, for this reason i will try to us the IMU outside the center frame

But with Gemini fc the story is different..and i see my same drone with same setup perfect fly with high wind too

All conditions..dji say "we know, and we will release a new firmware update"

Happen always, especially when you use the yaw..or you go forward..no way to control the altitude

do you fly with a X8 ? because the problem is only on this configuration..what i have to do now is to buy a Gemini, and try to sell the A2, because i can't wait "untill" they will make a new firmware update!

So the only way to solve is to buy Gemini flight controller..1000 euros of A2 are gone..or...fly away!

thanks guys! i'm not the first owner of these big X8 with A2 flight controller, and all ther other owners with my same setup has the same problem! With Gemini or Xaircraft flight controllers on my same setup the craft flight well with all wind conitions! i tried also all kind of vertical...

My coaxial x8 is equipped with U8 motors and 28"props..my main problems is the losing altitude!! Especially when i go forward of when i use the yaw I tried all the gains but nothing happen! I can adjust all the gains with my knobs..but nothing happen. We are talkimg of Devourer x8 from...

i bought these two items, this WORKS: http://www.infinity-hobby.com/main/product_info.php?products_id=10134 and this doesn't work: http://www.infinity-hobby.com/main/product_info.php?products_id=10220

solved, i replaced the hdmi board/cable with another brand..

thanks guys..but i think i have a hdmi cable broken somewere..now i have to buy it!

yes i'm using the GH3 zenmuse...where can i buy this cable? do u know some european or UK seller?

Yes, my GH3 camera is PAL, and i set 1080i as video out..and i tested also connecting my monitor directly into the video out of the zenmuse CGU, my video is DOWN always, and came back only if i touch the hdmi converter board and the hdmi flat cable...it could be a bad connection or faulty hdmi...