Recent content by Richlizard

  1. R

    Aeroxcraft Brushless Gopro Gimbal

    Blimey, this was some time ago. I honestly cannot remember what happened, but it is working now so I guess he did :)
  2. R

    Aeroxcraft Brushless Gopro Gimbal

    All done. It's being sent back, hopefully not an expensive job.
  3. R

    Aeroxcraft Brushless Gopro Gimbal

    Ok, thanks for the advice. I will contact Rob via pm.
  4. R

    Aeroxcraft Brushless Gopro Gimbal

    Hi CM. No joy. In fact, the last flight was worse than ever. The montage below shows an image taken shortly after take off and a second one taken just a few seconds later after a couple of control moves. The third one is the position of my camera at the end. Not only the lean to the left (it...
  5. R

    Aeroxcraft Brushless Gopro Gimbal

    Hi CM and thanks for the reply. Mine seems to happen in slow motion as it takes off, then stays there. I have had the bucking lots of times but as you say it settles down again... in my case to a 5 degree lean :( The nice man at Aerox advised the sliding of the cage too, but it made no...
  6. R

    Aeroxcraft Brushless Gopro Gimbal

    Could someone explain how to overcome the side lean problem? My gimbal leans around 5 degrees from the horizon and I am exhausted by the times I have changed the parameters in the software without success. It is fine before flight, but once in the air, slowly leans to the left and stays there...
Top