Recent content by Quad-SA

That was the soft landing. The last time I took it up it did the same thing from about 200 feet in the air. When it hit, it broke and arm and a blade and the camera gimble had some damage. When I calibrated each ESC, I plugged each one into the thottle port on the receiver #3 slot on Futaba. All...

Crash video Kloner, Here is the link to the video of what this thing was doing on the first flight. http://youtu.be/CvRkbQG9h2Q Still have not got it figured out. I have taken it to my local RC shop and guys that have been building and flying for years are stumped. I have programmed the ESCs...

Kloner, please explain what you said about "flashed with simonK". I am not that deep into RC and all the jargin that goes with it but want to understand it. I did speak with Ali over the weekend and we hooked up the Futaba controller and aircraft to the NAZA software. He was able to see all the...

The first time it crashed, the camera gimbal flew off which unplugged the battery and gimbal servos. I did not fly it until the next day and then it did fine after understanding that I needed to reboot it after setting home and finding the satellites. I flew it for about 7-8 minutes without any...

Sorry, This is an XAircraft 650 frame with 980 kvs Hobbywing ESC and Brushless Outrunner Custom 900kv High Efficiency motors. I fly it without the black plastic cover. I have attached pictures if this helps.

Thanks for everyone’s thoughts. I bought this as an RTF from Ali Shanmoa and have not had a chance to talk to him since they are 11 hours in advance on my time zone. Since it was RTF he set the controller settings. I will try to answers everyone question to see if you can help. I also plan to...

I need help to figure out what is going on. When I set up my quad to acquire satellites and the green light is blinking, I start the motors and only one or two will power up. If I push the throttle they eventually start, but when I tried to fly after this happened it fell out of the sky swaying...