Recent content by psindrup

Yes. Setting the endpoints on my transmitter to +/- 120% solved the issue, and I was able to set the endpoints on the ESC Peter

My ESC's do not have a build in BEC, so no need to remove any red wire. :-) I thought that the Naza was the "reference model" to use with hexa's? My gain settings are as follows: Base gain: 180 180 140 100 atti. gain: 120 120 Peter

Hi all During the maiden flight of my FT680 hexacopter - equipped with a Naza flight controller - I had two very strange crashes, and I have no idea why? It lifted off just fine, but after a few seconds it went crazy, as if it had a life of its own. Luckily I had my GF film the ordeal. The...

Hi all New here. :nevreness: Do any of you know where I can find a programming manual/instruction for the HVSK-40A Multicopter Brushless ESC 40A (OPTO)? I only need to do the basic programming of setting the same throttle endpoints, disabling soft start and so on. T.i.a. Peter