Recent content by poboy

The JST power connectors are labeled bass ackwards. For about two centuries, every electrical connector has been sorted with the "male/female" classification. Been workin' pretty good. Kinda easy to figure out. Maybe its just me, but just because you put a protective shroud around the male...

Let it out. You'll feel better.

Hey all. CS8 is 953mm shaft to shaft. 14" props have about 12mm clearance

Hey Gary. Thanks for the help. I don't have an xbee. Mkusb connected to nav debug. The values in screen 17 of koptertools shows normal values. ie; field:111, declination: 0.7, inclination; 0. Of course this is all with red LED still on. On screen 16, (magnetic field) , x is around 172; y is...

No i have not flown with nav board. It is new. Thanks for the info droider. That particular forum is very hard to read as the translations are so poor. I'll give it another go, though. I expect that a normal nc would only need compass calibration one time, then should be okay (no red LED) on...

Anyone? Bueller? Buellar?

After i calibrate the compass on the nc, the red LED goes out like it should. Then the next time i turn the bird on, red LED and compass error again. This is first installation of nc/mag and gps boards to a cs8 i been flying for couple of months. Thank you for your input. David

Hi Folks, I been reading and learning here for a while. I been flying rc helis for a number of years. I currently have an X-cell gasser; x-cell 30 and an Eflite blade 400. I am new to multis. I currently am flying the cinestar8 with cs 360 gimble / mk electronics. It is an awfully large...

Wow Craig. Unbelievable timing. I just got on this forum as well. My name is David Pope. We have just started flying a Cinestar8 been flying it for three weeks. (baby steps). Lets get together. Ima call you. thats so crazy