Recent content by Phospherus

Im running a y6 on a Jakub frame with 2814-11 and 11x5 Graupner and my yaw gain is at 130 and is rock solid. This is a Naza with GPS.

Just thought I would post my mini review of this esc. I had bought a Carboncore X500 quad frame for a smaller ship just to fly around but was having a hard time finding a way to install everything clean. Ordered one of these and it fit perfect between the top and bottom plate with plenty of wire...

Hello I have a larger y6 with the following equipment. Jakub hexa frame converted to Y6. Tiger 2814-11s motors. FA-30 flashed esc. Graupner 11x5 props top/bottom Naza FC My problem is if I yaw slowly everything is fine. but if I give a deliberate yaw command after releasing the stick I get...

Been awhile since I messed with MK. But did you calibrate your compass?

Well I think they normally install these to filter noise from reaching your receiver when using the built in BEC. But most likely you are not using the BEC on a multirotor so I would say it is safe to remove them. I had these installed on some f-30a esc when I recieved them and later removed...

Have these for a hexa. Are these motors ok on 4s with APC 12x3.8 props?

I have a set of 6 in distro board on Rcgroups classified forsale for 350.00. Im willing to wheel and deal for multirotor stuff also. Frames and such.