Recent content by Paul881

I crashed my F550 and broke my Gimbal just before I was due to fly back to the UK so once back in the UK, I sent it back to AeroXcraft and they turned it around in 48 hours over Christmas so I could take it back to Dubai where I live. Great service.

I see that Dji have now released new firmware: http://www.dji.com/download/naza-m-v2-downloads/ Are there any brave souls out there who have upgraded to this latest release who would like to comment on performance? It is supposed to have fixed the boundary flight limit issue in v.4.0. i am...

Thats what I'm doing except I'm choosing channel 8, Aux and LD. So to be clear, you have S Bus from your Rx to your Naza and and the pitch control from your Rx channel 7 conventional connection to your gimbal controler? Update -> Cracked it! When I connected the Martinez to the Rx, I had the...

Can you please explain how you did that and what connections and switch/controller you use as that would be very helpful? Thanks:nevreness:

Can I do that if I am using the S- Bus connection from my Rx? I have tried connecting to Channel 8 of my Rx and it didn't work so I assumed it was because I was mixing S- Bus and traditional connections?

I have received my new AeroXcraft Brushless gimbal and powered it up okay and it appears to work with my GoPro3. I can turn and tilt the F550 craft and the camera remains fixed, so all appears to be fine. What I would now like to do is to control the Pitch of the camera using the LD knob on my...

I have asked AeroXcraft to set my gimbal up for 4s operation (14.8v) and I can't seem to find a BEC that operates at that voltage. AXC are saying it's okay to connect direct from the battery, so maybe I just go with that suggestion - they should know best.

Thanks CrashMaster, that aligns completely with what I thought. I have posted this same question to a number of forums and either got no response or the advice was to connect direct to the battery. However, for all the reasons you mention, I just felt that wasn't right. Next challenge will be...

So if your Gimbal board was 14.8V would you use a BEC or would you wire direct from your main battery terminal?

I have a question (actually, three:nevreness:). Do you guys: 1) Run the power off your battery direct? 2) Run the Power via a BEC? or 3) Use a seperate battery for your Gimbal? I have asked AXC to send me the gimbal I ordered set up for 4S LiPo operation but I have read that Naza doesn't like...

Thats great to know!

Why was the last post in this thread back in July? I have this on order and can't wait to get it it installed and in action!

Doesn't the BEC need to provide 7.4V?

Hi, I have just ordered the AXC GoPro3 brushless gimbal and am pretty excited about receiving it and seeing what a difference it makes to my AP. However, I have got a couple of questions: I understand that its best to power the gimbal via a 7.4V BEC. What BEC is reccommended that I can...

Thanks Pete!