Recent content by overexposure.nl

  1. O

    Naza-M V2 with heavy load - Dangerous?

    12 kg is heavy! , i fly a hexa with naza m v2 thats 7 kg ( with gh4 ) without problems greetings marc
  2. O

    Solution: Horizon trim issue with Tarot T-2D brushless Gimbal and standard Phantom TX

    @Maverick thnx for info and the Yes thats logical on the Wookong. Its just that the Phantom TX doesn't have enough channels to control Roll. So nobody sets it up like it does. But even that the TX doesn't output the roll channel The Naza-M does output the roll channel F1 This means it can be...
  3. O

    Solution: Horizon trim issue with Tarot T-2D brushless Gimbal and standard Phantom TX

    Yes I have seen the site from Riot, but they are not using the roll channel. They use the selection channel for the rate / position mode. I suggest presetting the mode to position mode and use f1 for roll so it can be trimmed in the naza software to 100% level
  4. O

    Solution: Horizon trim issue with Tarot T-2D brushless Gimbal and standard Phantom TX

    Some people like me , have an issue with the horizon of their Tarot Gimbal to be off by a few degrees. Somehow on the Tarot V1.3 software you can't trim the horizon in position mode. ( you can in rate mode but most people don't like rate mode ) What I did was using both the F1 and F2 outputs of...
  5. O

    Help* Differences between the cinestar and tarot 3 axis gimbals ? :S

    I have the rc-timer Cinestar clone with the ZYX-gs stabilizer and this works very good ( also bought the tarrot silicon damper system ) I had the same thought not wanting to investigate to much in none brushless systems and I think there will be good conversion kids ( brushless ) soon for the...
See more
Top