Hi Gary,
I can see by watching the video what Im doing wrong.
And yes I mean attitude I must of been still half asleep when i posted the original question. LOL
Thank you for your help.
Derrick
Ok so I set everything up on my Taranis earlier this summer as per the instruction on the first page and everthing works except I just could no get the Altitude Hold to work (Im not using GPS right now).
When I set up a 3 position switch as per instruction and they seem to go to the correct...
Hello everyone
I have been flying an old Gaui 330X all summer and want to build some thing bigger more visable and longer flight times
I dont plan of any heavy lifting just GoPro and FPV gear once in a while.
My Idea was just bigger for visual reasons when flying line of sight.
Here are a few...
Just did as you said
Im all hooked up but Im getting an error message popping up on the Assistant it said: X1-EER
(You've Chosen parameters tuning by X1/X2 channel with knob,but no signal detected on X1/X2 input channel,or TX didnt power on)
Also tried motor test again and nothing
Plus when I...
I tried doing the motor check in the Assistant but the motor will not turn
But I turned the throttle off and on a number of times and can visually confirm the props are tuning the proper direction
May be Im missing something
One thing I was not 100% clear about was the whole Xbus connection...
Rotation seems fine
Also does not explain the throttle up problem??
If I hole the quad on a table from the bottom up can feel the motors throttle up hard when you give it even slightest input with the up Elev for example
And up can feel the quad trying to push hard to the forward right position
HELP NEEDED PLEASE
I have a Taranis radio I set up with a Naza V2 as per the instruction above with A Gaui 330x quad
All it wants to do is flip over violently
I had the exact same problem when I tried to program the Taranis with the Original flight controller that came with the Gaui 330X
It...