Recent content by mrself58

I am currently flying a F450 with NAZA lite & GPS. Was wanting to upgrade to FPV/OSD. Since I would have to upgrade the NAZA I was looking at the TBS Core Pro with GPS ( it is a lot cheaper than all DJI). Question is will the bird fly with two GPS or will they confuse each other???

DJI 330 with NAZA lite, flew good, finally installed the GPS. Got the Tx programmed correct (all modes turn blue)? The problem is now when I start it up it goes high idle ( starts to take off when throttle is down) and after a few seconds the motors shut off. I was thinking a failsafe but any...

can you check that with a voltmeter??

OK guys, I know that I am a newbie but it looked simpler???? than it is. I bought a DJI F330 with DJI 2212 motors and DJI 18A ESC's. I put a NAZA lite and a new receiver on it. thought that it would work. NOTHING. The receiver lites up (acts like it was binded properly) the NAZA LED...

You , my friend, are a genius and my new best friend. Did not know there are 2 types of ESC's. Expensive ??? lesson, will know before too long. As long as the problem is found the solution is a whole lot closer. It did melt some wires together, got that fixed, had some spares, just hope no...

Guys help me out. I thought I was doing good. I had gotten a F450 from ebay and was supposed to be bind and fly. Being a newbie I thought I could handle this. Anyway it had a KK2.0 FC on it and I could not make it work. It would power up and I could make one motor at a time run. Anyway I...

Recently purchased a F450 off of ebay (bad mistake). Anyway------ I have a Spektrum AR6115e receiver and the KK2.0 controller. I can bind my Tx to the Rx OK. (the light blinks like it binded). When I go to the controller, nothing, it is lit up and works but it is not getting the signal from...

still got these parts

NEVER MIND.............. No GPS, the wind got it, and well, you know the rest of the story....BUMMER

My Phantom started blinking yellow lights, when I hooked it up to my laptop and tried to change some parameters it said GPS required for this. I was told that a switch in my Tx had gone bad. How can I troubleshoot this without having to first replace the switch? It will still fly like it is...

How close to McComb??? I fly a Phantom (FC40) and I like the way the Phantom flys. I have had it for a while and am fixing to upgrade to the 450 series. If you are close to McComb we can fly one weekend

I am wanting to install an iOSD on my Phantom. It has the stock FC40 camera with it. Will the iOSD work and what all do I have to purchase to make it work. I am currently using my iphone for FPV

I recently purchased a Phantom from Amazon. I got the Phantom FC40 which I thought was the Phantom with a camera. I just looked at the model and serial number and it is a modelP330D and the serial number ends with V2.0.0 Now is this version 2 of the Phantom 1 or is this a Phantom 2.

New to this forum. Been doing R/C for a few years but just got a quad a couple of months ago. DJI FC40, it is a pretty good quad but there are a few shortcomings. Have not "cracked it open" to see what is inside but I do see FPV and OSD coming soon. Anybody out there close that would like to...