Recent content by moleware

HOLY CRAP IT WORKS!!!!! I started following this link: http://www.xflysystems.com/blogs/new...e-for-dji-naza (thanks BC-deGraaf). Eventually, I power cycled the device following basic and advanced calibration, and it just WORKED! I have it in Manual mode, and it was blinking RED at the time...

I look forward to your findings, please make sure to post them here!

I have adjusted the max/min of the gear servo so I now can switch between Atti and Manual modes. I also re-calibrated the sticks several times, and even tried setting the gains to 150% after calibration. Still no arming. The LED blinks yellow/amber 4 times in groups now in either mode. I...

I do have the GPS, sorry I didn't mention it earlier.

Ok, update: I adjusted the max/min range values on the gear switch to +/- 80%. I now can switch between failsafe and manual mode. YES!!! Unfortunately, it is still not arming the motors... Now the LED blinks amber in groups of 4. The DJI LED code page is completely useless... What does...

I have a DJI F550 w/ Naza-m V2 and Spektrum Dx7. I have calibrated, updated firmware, and checked all connections more times than I can count. I cannot arm the motors. The copter appears to start up and initialize normally, then the LED blinks amber only and does not stop. This indicates...