Recent content by mikael

which logger did you go with, just curious as I am looking to get one also. Thanks

Thanks!!

i've actually been curious about that myself. Can you recommend a good logger?

I've not run a logger on them. Website says 40A. My hobbyking 40A blue series are rated to a burst current of 60A. Nothing ever got hot in my previous builds with this setup but I haven't flown the f550 enough to see if it gets hot beyond 5 minutes of flight. is there cause for concern with...

They are rctimer 2836/9 880kv. I've been using them in all of my builds including dji f450 WKM and Hoverfly Pro with no major issues.

You are welcome, I didn't have any problems with the software. Just make sure the dji driver is installed, that you have an internet connection, and that your login info is correct.

Thanks, current mount temporary until I can figure out what gimble to buy. I was surprised to see how vibration/jello free the video looked mounted to the frame

Here's the first flight with Go-pro hard mounted using Velcro and a zip-tie.

Thought I'd post some setup photos of my build, not done yet but getting there.

What pattern is the LED flashing?

No worries, You are welcome.

From the manual, last sentence.

Hi Rob, I had the GoPRo set to R3 which is 720P 60FPS. I think the fishbowl view is more apparent when there are close objects or the horizon is above or below the middle of the screen. I've shot plenty of video in R3 where the fishbowl is in full effect.

Well, I flew the wk-m for the second time, this time with a camera. Still need to tune and practice more but it flew really well I thought. The wk-m is mounted on a flamewheel 450 and the gopro is direct mounted underneath the forward tab of the flamewheel using one of the double sided sticky...

Thanks for your replies. It it would be great to get a definitive answer from DJI on the fault tolerance subject so I'm going to write them and hopefully get answer. Has anyone asked and received an answer from them? More than a few DJI users are flying expensive gear including frames, cameras...