Recent content by mattsPVC

Some FPV flying with my 3 Axis Brushless Gimbal.

3 Axis Brushless Gimbal Test Finally got another board to test the yaw axis on. I used the "Follow me" function for the Yaw in the GUI. 2x Alexmos Simple Brushless Gimbal Boards. (Firmware V2.0b4) Yaw Axis motor: LD-Power 4008 GM4008-57 Roll Axis motor: iPower GBM2212-80T Pitch Axis Motor...

Putting the ROLL back into AlexMos V2 This time I have linked the yaw stick to the roll on the gimbal. By using the channel mix feature on my Jr Dsx9 radio. I was able to link the Gimbal Roll to the yaw channel. I then changed the servo speed setting (for the Gimbal Roll) on my radio to 2.5...

Some more videos with my 2 axis gimbal

Putting the ROLL back into AlexMos By using the channel mix feature on my Jr Dsx9 radio. I was able to link the Gimbal Roll to the aileron channel. I then changed the servo speed setting (for the Gimbal Roll) on my radio to 3.75 seconds to give a nice roll motion. Now when I move the aileron...

The reason I have made it small is to keep the arms out of the view of the gopro. Especially now with the Brushless gimbal in forward flight. I am not using a video switch yet. I just guess where the gopro is looking. A video switch is next on my list. I don't feel that bad about using a kit...

Thanks Nic. I bought three. I will keep one for parts, your welcome to have the other one.

Talon V2 I have been searching for a replacement for T-Quad for some time, now that my flying skills have improved. And I am less likely to crash. I have settled on the Turnigy Talon V2. Because it will save me some weight approx 150grams. And it has enougth space to fit the NAZA and power...

Thanks. Did it on the fly.

Yes I'm working on adding the 3rd axis. Just waiting to get my hands on another board.

DIY Brushless Gimbal (Pictures & Measurements)

DIY Brushless Gimbal (Pictures & Measurements)

Thanks. I used a 35mm film canister. I cut a hole in one end to fit over the lens. And used double sided tape to keep it in place. I then I trimmed it, till it was no longer in the picture. I used the LCD back to help.

My home made Brushless Gimbal. Made from cutting up 50x30x2mm Aluminium rectangle tubing. The unique feature on this gimbal is the wire rope can be easily removed. And consists of a single loop of wire. This wire rope can there for be easily changed for a different length, in order to get the...

A little info on my home made gimbal And the results.