Recent content by Joesrevolution

Hi guys, Had a bit of an accident with the fc40 the other day, I was really struggling to remove a battery pulling hard, untill it finaly let go having me pull on the connector very abrutly. Long and short the VCC joint on the distribution board has pulled straight out revealing green pcb...

Hi guys. I'm fairly new to Fpv and OSDs. Having had my first proper flight today using an immersion ezosd with immersion 600mw tx and immersion go pro cable. (Felt that going all immersion would remove the risk of any compatibility issues...) On my dji phantom. I'm running nimrod cloverleaf and...

Thanks one-stop. Will the not connected seccond audio in cause any problems? I heard that the ezosd uses an audio in for telemetary from somewhere although I see no reason why that would be the case.

Here is the wiring diagram for my vtx i dug out. it seems that it is the same as a immersion but there is only one audio in line. What does the NC port stand for? is this just not connected?

Hi guys. Hope everyone is manangeing to get out with your quads in these winter months... I know I am using every opportunity to get my phantom up. My question today is I am looking at buying the ezosd Om screen display and was wondering what the compatibility between itself and a different vtxs...

Thanks very much for the excelent advice Kloner! Will be ordering a 8j today! :)

Also how simple is it to configure the failsafes for the phantom? I only ask because i know you have to configure them for the spektrum... will they just work out the box on the 10J?

Okay sounds like im going futaba then! So to be clear if i wanted both gains and gimbal control id need the 10 or the 14? But i could run the 8j if im only interested in gimbal control?

Awesome thanks for the reply! Is it hard to programe the receiver to work with the 3 position switches to how they would be on the standard remote? Also would it be possible to use the gimbal control lever with this radio?

Hi guys! I hope this isn't a really newbie question here but i'd much appreciate it if some light could be shed on this for me. Im looking to convert my FC40 to a 2.4Ghz control system (ideally the Spektrum DX8 with the AR8000 receiver) so that i could use a 5.8Ghz FPV system as 2.4Ghz for fpv...