Recent content by JasonV

My guess would be the demand is not there.

Unless I am mistaken I think RC airplanes have been around longer than you are saying. http://en.wikipedia.org/wiki/Radio-controlled_aircraft one of the first sites I pulled up doing a quick google search.

Check out PbNation.com I have always liked their forums. RCU is friendly as well. DIY Drones is the worst set up forum I have run into so far. I also like RCgroups but wish they would limit the thread size like PBnation It looks like PBnation is 2014 vBulletin Solutions Inc

I would drive this one at least once!

I did alot of research before I bought my DJI products. I read all the fly away threads and spent alot of time on social media sites researching my purchase. From what I have seen there is very few legitimate "flyaways". Most problems that people have are found in the manual no one reads and...

I disagree, I am very happy with my DJI products and so are alot of other people.

I ended up removing all the bullet connectors and soldering the motor leads right to my esc's.

I have not seen one on a quad yet..Seems like it would be just as easy to unplug the battery.

Here is a build log of someone doing it. http://www.rcgroups.com/forums/showthread.php?t=1779003&highlight=f550+quad

That clears it up, I bet he was referring to that as the servo plug.

Man, I bought my F450 arf a month to early. Now I will just have to buy a F550.

"My question is: I have a spare XT60 to banana charging cable, if I was to clip and strip that and solder it to the distribution board would it work or would it cause something to burn out?" I think he is asking if he can cut the bannana connectors off and use the XT60 with leads to solder...

Are these what your talking about? http://www.mcmaster.com/#retaining-rings/=qndjt0

I was reading that before I came over here. Keep in mind it was posted by an acct newly created with 1 post.