Recent content by ImCole

Here is a bit more information that might help: So I just checked my wires and they turned out fine. I have my 4 ESCs pluged into the motor spots on the KK board and then my 5 Servo wires going from my RX to my board. Then I tried booting it up all wired and ready. A few things happened now: All...

Thank you for the help so far! I have overcome the original problem, but now I have a new can or worms opened. So here is my problem, when I take my KK 2.1.5 board and plug in all of my ESCs and then plug in the battery, the board works fine. But next when I start to even touch my RX cables to...

Ahh, makes since :)

Hmm, I've never done two batteries but I have seen it. Just wondering, why you are spending so much on a first quad? Is it going to be for video? Oh and also you should look for a canopy for that frame to protect some of your parts...

Get extra props and also probably two BIG batteries since it looks like you want a really good quad. Make sure you have a BEC as well since your ESC is an OPTO. If you don't already have one get a good transmitter (probably around $150). BTW your props are a bit big for those motors which want...

Thank you for the reply! I have to wait for my replacement RX. I will put some heat shrink on the ESCs as well. I also did program them to the suggested settings right before the RX blew.

Okay got my location updated :) Now, the KK board works fine (it lights up and does what it is supposed to). The RX was fine and was bound before it blew. Lastly, I was able to get the motors to spin once after I had programmed the ESCs, but after I had unplugged the battery and restarted the...

Hey man, I recently made the bad decision and didnt buy these. These are really good ESCs. You dont need to flash or program them.

Hello, Recently I have decided to build a quadcopter from scratch. I thought it would be somewhat easy considering I have been researching this stuff for about a month. Here is my parts list: -Hobbyking 2.1.5 Flight Control Board ...