Hi all, its me, Andreas B., developer of the Herkules ESCs.
I was pointed out by Amerly to the Super X controller. Seems to be on the right way and really an alternative to WKM.
So we are open to work close togehter with XAircraft America as i belive we could complement quite well.
Herkules...
Hi,
the website is not down! I did not recognise that there was any server downtime. Can you please tell me when this happend? I will ask the provider if there was any disturbance.
From my point of view the site is stable.
Hi,
you are right. The user manaul was reworked completely. But there are no "new" configurations described. There are only "more" configs in. As Herkules is currently mainly used for DJI WKM and Mikrokopter, these two main systems are described in parallel. There are a lot of possibilities more...
You can now also download the latest detailed User Manual for the Herkules III on www.andreasbaier.de .
Please register first to get access to the download area.
Andreas
Hi all,
four answers in one post... i hope this works ;-)
Answer 1: Please Register by using the contact form on www.andreasbaier.de. I will send you quickly the login data for downloading the user manual. Meanwhile it is pretty detailed and has lots of different settings for DJI WKM and...
Hi All,
the USER MANUAL for Herkules III Setup is now online. As i am working still on some chapters please check for updates in the next days.
http://www.andreasbaier.de/index.php/de/downloads/herkules-iii-firmware/viewcategory/8-herkules-iii-programming-tool.
I included also description for...
This fits to my experience.
In case of using a coax drive with same motor and same props on both sides, the best efficiency with upper motor running 5...10% slower than the lower motor.
Means for the mixer to use 90...95% as value.
Thanks for your pictures!
The latest updates for ESC...
Hi Hexacop,
you have to load a special open-format configuration file to logview. I will put the files and descriptions to the software update and will put a description for this to the manual also. With this file, you can read all available parameters.
But there are currently not all parameters...
Yes, now Herkules works also with Jeti EX Protokoll... but...:
=> We decided to go a slightly different way with our telemetry!
We now use an additional controler board with integrated Datalogger on SD-Card which translates the Herkules internal protokoll to the different Telemetry protocolls...
Hi Guys,
there is another good working Koax8-Setting. This is even more safe with HERKULES III because:
1) The Top Herkules QUAD-ESC (all on one PCB) spin the Top Motors as a fully self-running Quad-copter
2) The Bot Herkules QUAD-ESC spin the BOT Motors also as a self running Quad-copter...
Hi Hexacop,
there is another good working Koax8-Setting. This is even more safe with HERKULES III because:
1) The Top Herkules QUAD-ESC (all on one PCB) spin the Top Motors as a fully self-running Quad-copter
2) The Bot Herkules QUAD-ESC spin the BOT Motors also as a self running Quad-copter...
The Telemetry Firmware is short before release.
Therefore you can load it only with a beta tester account.
We will put them to the official download soon.
Please write me a PM and i will send you the firmware.
Andreas
Hi Hexacop,
i dont understand your issue fully?
You are using DJI WKM?
If yes, then you dont have to seqeeze your mind with I2C addresses at all if you dont use telemetry.
WKM delivers only PPM signals, which you have to route manually with patch cables to the adequate motor connectors of the...