Hi There!
I have a F450 clone and with a 1000kV motor and 9050 props it works fine.
Higher kV motors have higher RPM but don't have the "punch" or "power" to spin larger props. Therefore having a higher kV motor with smaller prop is equivalent more or less to flying off a lower kV motor...
Hi there!
It's looking good however you might need to play around a little bit with the weight of your battery becuase there's a fine balance between the weight of the battery and the power output. For my 250 size Race Quad I used a 1300mAh and that seems to be the tipping point not so sure...
Yes you should connect it to your FC. I think I know where you're coming from in the sense that you would like to control the pitch manually for good shots. That can be done by changing some settings under the NAZA GCS. This is a better option as you will have the ability to keep your gimbal in...
Hi there!
Yes 2000kV range motors are definitely too small!
I run the Dji F450 and 1000kv motors already feel the strain with a 1kg payload.
Next time check first before making purchases.
Anyways you'll have more spare parts in your inventory on the bright side.
Cheers,
Flyer
Sent from my...
Hi There! First and foremost what FC are you using. Have you tried configuring settings in your Flight controller. If you are using anything related to dji or Naza, BLHeli has issues with it and only Simon K will work (Not sure if this has been solved). Could you send over pictures of your...
Hi there,
Gosh I can't understand your English! XD
Anyways is your flight controller a product of NAZA? BLHeli doesn't work with NAZA at all only SimonK. Theoretically a quad can still fly With ESC of different brands however it's dangerous and not advisable.
Try going to your ground control...
The CC3D is super easy to configure and use! Good choice! The Setup wizard should take you through all the board and transmitter calibration procedures. Try plugging the board in and check the transmitter tab for inputs. Make sure you also tell it what signal you are using becuase flysky Has...
If your flight controller has a Ground Control Station try hooking it up to your Flight Controller and checking to see if the Flight controller registers RC input. Redo the bind process and also check that your FC knows what signal type to expect from your receiver (PWM PPM or SBUS etc) In your...
Could you provide some technical specs? Eg flight controller, radio system? Could really like to help however do not have enough information.
Sent from my SM-G570Y using Tapatalk