Recent content by Hedonist222

Thanks Moto Yes, I'll be getting the plus version.

After binding, I'll need to add the quad profile to the Tx. I'll create a new entry, name it, then will I need to carry out other settings like rates, expo & so on? I'm not familiar with adding a new entry. The taranis manual doesn't explain the other bits.

I mean, would I need to run the vehicle setup & transmitter setup subsequent to binding tc to rx? I'm as noob in this aspect.

Air is thinner Less oxygen More nitrogen I imagine thrust will be weaker & you batteries will finish quicker because they're RPMing excessively to yield you the same power.

Racing multirotors are nothing like dji phantoms. By comparison, phantoms are like tethered hippos. Not very graceful but controllable. Racing quads are like lunatic squirrels. Zipping all over the place.

Will I need to run the vehicle setup wizard & transmitter setup wizard on open tx again?

What are the differences among modes? Is mode type dependent on flight controller type? Why would I need to setup those settings I the Rx? Isn't the flight controller supposed to be custodian of the profile?

I have an SRD260pro that came with a walkera devo 7 Tx. I've ordered a taranis xd9 plus & an X8R Rx. I need to know the exact steps to set it up. Obviously,I need to install the new Rx. Then bind the Tx to the Rx? What about other settings? Like expos,gaina, rates & other things I'm not...