Recent content by Ghiro

Same boat here, exactly the same set up, feel screwed up!

Thanks! That what i was looking for. Next monday i will buy the Zen from a physical shop but i was a little bit concerned about it.

I own an F550 with WKM and willing to change my Gimble with a new one, have been looking around and found out that most of these things require Arduino programming and things like that i do not have time to take care about since i'm using the mutlirotor exclusivelly for working purposes. This...

Any WKM user feedback ?

Hi Folks! After e few tries with a Photohigher 2 axis gimble with a GoPro i decided it was right about time to upgrade my WKM/F550 with a new brushless Gimble that can handle a Nex5 so i've looked around and got a little confused. I found a shop though , wich is only a coupple of a 100Km'a far...

Had exactly the same issue with WKM, MacBookPro/Win7 on Bootcamp. Can't wait to sort this out,my 50waypoints upgrade is useless and the PC is 17", un-portable to the field.

Without load i was fliyng for allmost 9 minutes with a lot of grunt, loaded up with all the video hardware and gimble the flight time came up to bearly 5 minute. When i first flew it all loaded i took it at allmost 80meters and it took a draft, it was very stable but handling weren't immediate...

F550+Apropriate gimble + NEX5 = to much weight for a 550... I'VE HAD THE EXPERIENCE... :(

Good point, i believe S-Bus RX's users wont see it as a problem though

Sorry for my ignornce but, what is it?

Dewster do you have an HDMI/analog video converter on your rig? If so wich one and how do you power it? Thanks.

Almost completed my build . Seems like we came up with the same solution with minor changes. I've decided to remove the GoPro plastic case mostly because of the lens cover, the camera is attached to the Gimble with Kyosho double sided gel tape. The tubes i used to hold the gimble to the L'G's...

faster spinning props gives more vibrations

Intresting.... i didn't knew there were some mounting "issues" and i would like to thank you for sharing your experience with this products. I believe i will work out something when the parts wil be in . You give me an intresting starting point tough . A virtual beer for you....

Hi Crinson, the aeroXcraft landing gear was ordered yesterday, when it'll be here i sure will post some pictures. Since you ask, i believe you think there's some problems match the two parts together, isn'it?