Recent content by Gerthart

Glad to hear that it is working!

Some of the recent injuction news hopefully doesn't impact their support services. It already needed a bad case of re-structuring to begin with...

You mentioned that you are using the CD? I would download the latest version from DJI site and give that a go.

Anything worthwhile you can share with us Dave?

S800 EVO Futaba 14SG w/A2 internal SBUS receiver IOSD II, H3-2D gimbal (not installed), just installed upgrade blades from DJI (untested). Running an A2 with v2.1 firmware. I still need to test the POI. The Evo suddenly jerked backwards in the air during a test flight on GPS mode and...

I have now flown my S800 EVO/A2 with v2.1 (no gimbal) three different days. I tested the following features: - ATTI mode - Go Home via switch, NOT by turning off my transmitter - POI - Landing gear retracts - GPS mode Attitude works well. Go home switch worked flawlessly numerous times. I...

Here is a fresh installation experience on win 8.1: - I installed the latest A2 Assistant Software v1.2 - I proceeded to run the DJI WIN8 Driver Installer as administrator by right clicking on the file and selecting "Run as administrator" <see screenshot below> - Followed the standard...

I vaguely remember how I got around to installing the driver. It did give me some problems when I followed the onscreen instructions. Giving up on that, I tried to update the driver manually through the device manager and browsing for the driver on my c:\ drive. It found it knowing that the...

Not flying at all. The 800 evo hasn't seen its maiden flight yet. Waiting to get some validation on the 2.1 update before I get the courage to get it going.

Great videos and thanks for the thorough testing, Dave! Looking forward to your additional tests. I may be flying my new S800 sooner than I anticipated!

Confirmed on my A2/S800 EVO. Seeing the same lights flashing that isn't documented yet.

Glad to know it wasn't just my installation. Good find on TX lost/failsafe not displaying correctly. I'm going to stick to the PC version until these kinks are ironed out.

Thanks, Dave.

Can someone else verify if they are seeing the same behavior as I am. While I was calibrating an A2's end point for GPS/ATTI/Manual setting, it did not light up the GPS/ATTI/Man setting like it does on a Windows version. Is is just my installation or are you seeing this on your OSX install as...