Well done. Sensitivity can also be adjusted by tweaking the attitude settings in the DJI configuration panel. Try different levels of expo - start low and increase until you prefer the response.
You need to measure the distances and input the offset. Tape measure will do it - nearest centimetre will suffice. If it occurs only in power up - you compass maybe too close to the electronics etc - there is interference. Have you done the compass calibration?
The range is specced at 1-2km I've never taken it further than 400ft/500m as that is the limitation in the UK under CAP722.
Have used both full waypoints and click and go. Both work well.
Sent from my iPad using Tapatalk HD
Spoke with DJI. Currently it is not possible for customers to export the data - the logs are for engineer access only for post flight troubleshooting. The DJI Ace One (for helicopters) CAN export - this is because the data is recorded on the hardware. With the Woo Kong it needs to be...
Check the Ground Station directory folder where the software is installed. There is one folder for saved missions and another called logs. May or may not be the solution as I've never needed the logs for post processing.
Hello - I had a similar problem initially - Green flashes indicate that the flight control system stability is compromised. The only way we solved the problem was by rewiring - therefore we believe that the IMU was being affected by Electronic Magnetic Interference from the wiring/power...