Recent content by ferdy55

hi i have recently gotten a zenmuse gh4 gimbal and am controlling with a futaba t8j. at the moment it is setup with pan and tilt on aileron and elevator channels with roll being controlled by rudder. i am new to futaba and i am trying to switch the tilt to the throttle, and the roll to the vr...

all good now i had ultra pwm escs selected i was meant to have normal thank you jeff much appreciated jon

heres my setup 4 escs going to minix fc red wires cut fc battery cable plugged into jst which is coming from pdb osd to osd gps to gps sbus cable to pwm/sbus converter http://www.fpvmodel.com/rmilec-high-precision-pwm-ppm-sbus-signal-converter-v2_g478.html 6 jumper cables from other end of...

fpvone i have the flight controller connected to battery via jst plug coming off pdb i am using emax 12amp esc with simon k flashed on them how would i get power to the receiver without the esc? jon

hi i cant seem to get the motors to spin i am using walkera devo 10 transmitter and devo 6 channel receiver i am converting pwm to sbus using converter i have calibrated sticks done reverse calibration and compass calibration i can see that the flight modes are working from the led i can also...

the 1038s fly nice with the 4s feel your motors after a couple of minutes of flight to make sure they are not getting too hot ferd

where did you get those perhe

hey pcm try checking this out http://www.ebay.com/itm/DYS-Gimbal-Brushless-3-Axis-4108-Motor-Evvgc-Controller-f-Sony-NEX-ILDC-Camera-/371043298704 not too shabby ferd

at the moment i am using 1038's with 4s lipos on a 550 that has also got iosd mini boscam tx can hub/bus zenmuse 2 axis gimbal gopro 3+ definitely try the silicone dampening kit you will be very pleased ferd

yo corgi try getting the vibration dampening kit with the silicone bits instead of the rubber ones i get no vibrations/jello ferd

Try using silicone spacers insteadead of the rubber one. I have the same landing gear and i get no jello

Very similar to my own setup what kind of flight times are you getting? Ferd