Recent content by Dyver76

I missed under stood that section. I thought the z value was the distance from the top of the puck to the bottom plate and the x and y was the offset from cog. I didn't think z would ever change unless you changed the height. I might need to see a video on this to get it.

Isn't the x, y and z measurements just the offset distance of the GPS puck from the center of the flight controller? And the flight controller should be a cog? If so then you shouldn't have to keep changing there values unless you change either of the locations. Right?

Thanks that helped. I had motor 1 and motor 2 swapped on the FC. Seems to be working now. I doubled checked everything on the assistant several times but did not think about checking motor wires. Now I just need the snow to go away so I can do a test flight

I have been following along with this build. I have the DJI 450 with the Naza lite controller. I haven't had a chance to take it out to an open field to fly yet but I have tried to get it off the ground in my yard. the problem I am having is it wants to flip over at the moment of take off. I...

thanks sledge I am going to try that when I get a chance

I just realized I responded to the wrong topic but I think this answered my question

thanks, I will try that tomorrow and see if it acts any better

I just recently purchased and set this radio up for the NAZA. Everything works like it should on the Naza assistant software. I also set up a switch to do a force failsafe. When I hit the switch on the Naza assistant it works fine for every mode. So as a test I fired up the Quad with no props to...

Thanks sledge, I think you answered my next question which was what mode I wanted to set up in. I have an old Futaba T7CHP(72mhz) that I forgot I had that I am going to use till I get the funds to buy a better one. Now all I need to do a battery and I will be ready to start working on this...

Thanks for the welcomes and the pointers. I do have experience in R/C cars but none in airplanes or heli's. I have been playing around with a toy quad (Traxxas Alias) for a few months now and decided I wanted build one. I got a DJI F450 combo that came with the motors, escs and naza lite/gps. I...

Just got a frame kit for x-mas and I am starting to get into multi rotors. I have no experience in r/c aircraft of any sort so I might have a ton of questions