Recent content by drewj

Hi all, I have a 5.8ghz tx-tx with for doc. It worked the first time I plugged it in and now I can't get a signal. I thought I fried the tx but I tried a new one today still getting no signal on the lcd. Any body have any tips for fault finding? Thanks

Default 100, 100, 100, 100%

Ok so it takes off now but drifts in all sorts of directions and doesn't stay very stable. It will hover but usually at a slight drift

Ok, so I just took it apart bit by bit, put it back together and reset it up and it works! horahhhhh thanks for the help

its on quad-rotor x which is right for my setup

just tried that no difference

its almost like its correct with the 2 motors from opposite corners. one of them is defiantly right but either the other is underpowered or its taking the other corner motor.

So I have checked over and over and they are defiantly plugged in the right holes. But it does correct with the wrong motors, so I wonder if I should swap the ports over?

I will double check again when I get back, I have a feeling that because the controller is sat on the bottom of the frame (with the top stuck to the frame) that I may have it backwards. I did take it off last night and check, but I may be confusing the port. Anything else to test for if this is...

Yep, I have checked, checked, checked and checked again. Its so frustrating. All the motors spin in the correct direction according to the DJI NAZA M lite software on a quad with my setup. M1 CW, M2 CCW, M3 CCW, M4 CW. Props are all on the correct way matching these CW props have the air scoop...

Hi, I put together a Quanum Venture FPV with DJI NAZA-M Lite from hobby king, I have been trying to get it to fly for weeks. I have gone through 4 sets of propellers (currently on carbon as they don't snap.). I have been over all the FAQs fault finding, forums etc.. tried all the advice others...