Recent content by DmSk

CASTLE PHOENIX ICE LITE 50 ESC + YS X6 + CineStar 8

CASTLE PHOENIX ICE LITE 50 ESC + YS X6 + CineStar 8

With these settings, and 8 motor installation consumes a lot of power. XT60 connector almost melted. Had to install Motor Timing to 0. Looked through the logs from the controller, then why get a large drawdown of battery voltage (MaxAmp 11,000 mah), I realized there is a trip because of this...

OK, thanks for the weekend try.

please tell me the СС controller settings (PWM Rate, Motor Start Power, Timing) I have checked all the settings and do not know what they were by default ..

Yes ("Chinese"). and the WKM you how to calibrate? stop motors can be connected because of the failure of synchronization, it is necessary to change the timings.

there was a problem YS + CC :( Starts all ok. but 80% of the trottle (kopter keeps assistant) multiple engines are cut (not cool) .... the battery cables hot (12 AWG) timings CC exhibited in mid (14x4.7 props, motors are: QC-3328 http://www.quadrocopter.com/QuadroPo...328_p_392.html BATTERY...

there was a problem :( Starts all ok. but 80% of the trottle (kopter keeps assistant) multiple engines are cut (not cool) .... the battery cables hot (12 AWG) timings CC exhibited in mid (14x4.7 props, motors are: QC-3328 http://www.quadrocopter.com/QuadroPower-Motor-QC-3328_p_392.html...

Please help What parameters should be set to "Customized Parameters" YS-X6 the instructions are the coefficients for the "QuadX", "+100, -100" and for oktokoptera kaie values ​​are? (I think the values ​​of the mixer will be from 0 to 100)? or where to find a ready table for OCTO + (model type...

I think half a year CC and YS made ​​steps towards each other. Happy New Year

beeps when the power of the ECS is exactly (with the transmitter throttle to maximum). that is, some ESC+ MOTOR work and some do not? Did you use a function GCS YS-X6 "INIT Setup" in the calibration?

When you turn on esc, THROTTLE to maximum Melodies are played, with the inclusion (2-3 SEC) THEN throttle to minimum before the calibration procedure ESC must undergo calibration transmitter sticks(chanel alignment), after which the controller produces on SC has its own range of later try to...

with the latest firmware <tbody> 4.02 Beta 09/12/12 </tbody> it worked Motors: QC-3328 http://www.quadrocopter.com/QuadroPower-Motor-QC-3328_p_392.хтмль ESC: Phoenix ICE Lite 50 Settings: 1) Turn on the power controller YS-X6 (ESC OFF) 2) Click "init setup" in GCS 3) arm motor (stick V...

got to deal with the problem?

on what firmware checked?