Recent content by CopterCop

and 35% off 2.4Ghz AV FPV Reciever Codes can be found here: http://rcsearch.info/hobbyking/buddy/?u=MattB#catalog Some are UK warehouse, but some International ones there too. Matt.

Looks good. What's the diameter and spacing on the CF supports? I'm wondering if this landing gear would fit a bumblebee - it looks better than the BB CF one, and the BB already has the support rods - if they're the same...

Looks like you have a helping hand for one of them, so only one to hold, and you can do "chopsticks" with the iron and solder in the other hand easier with a smaller iron) . Alternatively if you have a bit of length in the wires, snip off the tinned wire, trim back the insulation, twist the two...

Hard to tell with all that flux (how are the silver earrings coming along?) ;) [Lucky for you the board is well masked and the pads are gold plated, so you'll survive], but to my eye, there's too much solder. Clean her up and go again. No need to put any solder on the pad before you start. The...

I'm guessing you're done by now (I signed up yesterday to reply but didn't have access to email to validate my account), but for the benefit of anyone else finding this thread, this fun guide to soldering might prove helpful: http://mightyohm.com/files/soldercomic/FullSolderComic_EN.pdf For...