Recent content by camryn

  1. C

    ESC beeping

    We have been powering the reciever from it's own smaller pack and then plugging it into the flight packs. :/ If the ECSs do not provide power I can see the voltage boosters not being helpful. We think somehow we need to provide power to the ESC rail but don't know a safe and/or correct way to...
  2. C

    ESC beeping

    Yes, they are.
  3. C

    ESC beeping

    Okay so here are the photos I took. But if you need a different angle or different photos all together let me know and I will send them your way. http://imgur.com/gallery/NNrTs/new
  4. C

    ESC beeping

    Okay I will send you photos ASAP once I get home from work. Thank you for all of your quick replies. It has been a very frustrating and disheartening problem.
  5. C

    ESC beeping

    I'm afraid we have already done that as well :(
  6. C

    ESC beeping

    It goes full up and down and it stays there.
  7. C

    ESC beeping

    We are able to connect to it and it reacts to the transmitter and will arm. So I would think so. :/ We have the black one.
  8. C

    ESC beeping

    It is flashing green so we do have it armed. We were just informed we need "signal boosters" such as these: http://hobbyking.com/hobbyking/store/__8356__Turnigy_Rx_Servo_Signal_Booster_2_7v_5v_.html We are having a hard time finding them in stock though. We were told we need 8 and HobbyKing...
  9. C

    ESC beeping

    Bartman, we tried what you mentioned but it didn't work. I also read in a lot of places to remove the red wire from the ESC's. I tried this and it also did not work. I also saw a diagram in which it said to plug a 5v BEC into the ESC power rail but I am unsure of how to do that on this board...
  10. C

    ESC beeping

    I'm afraid this didn't work :/
  11. C

    ESC beeping

    So does the flight controller need to be armed? I believe I need to set the throttle endpoints for this however, after attempting to do so it does not seem like it worked.
  12. C

    ESC beeping

    Thank you for the reply! Why is it that I need to separately power the HF Pro? Also, do I need to arm the flight controller before I power on the ESC?
  13. C

    ESC beeping

    I am building an X8 using KDE motors and ESC. Every time the copter is connected to the battery the ESC (or possibly the motors?) start beeping and do not stop. I have looked around and a lot of people mention the throttle calibration needs to be done. I have a hoverfly pro and have read that...
See more
Top