Recent content by BumbleBeeTuna

Its about 9.5 pounds without the lipo's and camera

Hi JDFelosi - Thanks! The 3 blade setup are using DJI 1552 props with KDEDirect triple prop adapters, they equal out to a 15inch prop. I like the 3 props cause they are super stable in high winds and super smooth/quiet. They are on the softer side though but! Because its 3 blades, it has the...

Decided to try both Pulse 10,000mah lipo's in parallel for the first time! Total flight times are as followed: Without gimbal/camera, single Pulse 10,000mah lipo - 23 minutes flying (not hovering in 1 spot) followed by 2 minutes before low voltage cutoff With gimbal/camera, single Pulse...

Awesome, thanks Cheshirecat!

Hi, I have an opportunity to pick up a new Futaba 8j from a buddy of mine for dirt cheap (letting it go for the price of a Spectrum DX5E). Comes with the stock R2008SB 2.4GHz S-FHSS receiver. My current controller for my copter is the Futaba 10j which runs a R3008SB receiver with T-FHSS. What...

I love the Arris Zhaoyun Pro with 32bit control board...does wonders! I'm using a Sony NEX 5t and its super smooth!

Here are some updated photos from over the weekend. Got the ground station up and running. Soooo much fun flying with FPV on deck! Hope yal like! Videos to come soon!

Gimbal and the camera came in! Stoked! This gimbal is so clean and smooth! Can't wait to get it into the air.....and learn how to actually use my camera lol I just need to extend the legs a bit to get the gimbal up off the ground.

Haha, yeah, the stand is from Overdose Racing which was used for my RC cars. I just set in on there from time to time to test the retracts or when I leave it on display with the retracts up. I plan on picking up this gimbal sometime next week...

Yeah, im looking more for stability cause i will be adding the gimbal later down the line. The motors are KDE Directs and ive stuck a micro v cam on board and so far, i got zero vibration. The motors run super smooth and come balanced from the factory, im worry free of the vibrations right now...

Same here on the Nano's, heard they have been doing pretty good. I'm looking to pick up at least 2 more sets of batteries to run parallel, you got me thinking now on the nano's lol. Makes sense with the p-51 4 blade setup, im running 4014-380kv motors and i have plenty of grunt to spare. i found...

haha! yes, i was bit off with that 1000-1500 "safe point". I'm just speaking from the very low point if it ever gets down to it. But yes, i always land with 3.75-3.65 cell readings comfortably.

I know what you mean :) I've honestly never taken it to 3.50. That is my last warning which the buzzer are set to. When I land, I'm reading at 3.75-3.65 on all cells across. The most I've put back on the pack is 8200. I've got about 10 flights of them I'm usually putting back about between...