Recent content by Bruiserbill

okay problem has been solved I pulled out the bullet connectoram fill the female and with solder un. salted the male part and put the bare wire in the solder filled female connector seems to be rock solid now.

its a relief to hear it works I am going to solder this morning. Did you solder to the wires direct or to the female end of the connector? Bill

not a bad idea I think I will try that with the motors in question question before I commit to all 6. won't be happening today though I am on my way to work

Ok Finally had time to play around held the multi copter by it's gear. ran it looking for the motor that cut out. after i found it i pulled the bullet conectors out just slightly to see if i could get a better connection. Problem has seemed to vanished. Heres me blaming naza for a bad...

I am not sure of the make of the transmitter, just know its 1000 mw. 1.3 ghz. I also notice a bit more jitter in the servos when i plug in the video tx. but regardless it acts the same. How does one test esc's?

what is the mag. it seems the lower the gaims the worst a problem

Hello all I am brand new to this forum, thank you for having me. The issue I am having is that I have a 550 with naza, gimbal with gopro, Video tx 1000mw and the main battery is 3s 5000mah, battery for video transmitter is 3s 1100 mah. Once the bird get into the air it will dip on one side...