Recent content by BraultJulien

What do you think about a single 22000 Mah? 2580 G (40C)

I just bought a DJI S1000 and im about to decide what batteries I will be using. I am hesitating between a big one and two in parallel. I heard that its safer to have two because if you lose one cell, You will still have full voltage. Also, it will only cost me "half a battery" . The downside...

I want to start using a Logbook with my UAV. Do you know any web site where I can buy one? I don't want a "pilot" logbook. I would like sections for weather conditions also. If I don't find one ill make it myself ;) Thank you!

https://vimeo.com/m/90215577 take a look at this

The Gh4 is 83.9 mm (large) and the Gh3 is 82.0 mm (large). And yes, 10 g more heavy.

I am planning to buy a professionnal Octocopter (maybe the dji s1000). I was just asking myselft if it will be possible to use the Movi Mr from freefly on the dji S1000 to be able to carry differents cameras with the same gimbal. And even bigger cameras. What do you Think? I find that the 5D...

Yes, my arms are a little bit twisted too. Forgot to tell you that ;)

I am just going step by step. I just baught the sunnysky motors and my Graupner Eprops. I will try to fly it with what I have (which will work) and when I feel that ill have to upgrade, I will. You don't understand why I upgraded to aimdroix, that's why: My arms aren't straight because...

No, I confirm that its not the gains. I could be : 1: Imu 2: arms 3: Motors My yaw problem is a left drift

More mm = more stability. These arms are light so it doesn't add a lot of weight. I think.. These arms are Out of stock right now. Should I update my order for the regular size arms? i just thaught, like I said, more mm = more stability for image. Also.. I have a yaw issue. So that's why im...

Here is my Setup: DJI F550 (Ordered the Aimdroix Extended arms) so it will be a F650 Graupner 9x5 Eprop SunnySky 800 kv 2212-16 +- 2800 g 4S ThunderPower 5400 mah Wookong M My question is: Should I upgrade to Graupner 10x5 props? If I calculate the amperage for each motor on a table...

I tried to stabilise my drone in manual mode but I was not capable of maintening the altitude. Ex: 60% throttle: the drone was going up and one step lower on the throttle it was going down. I think that I can fix that in the menu of my transmitter

I bought 9*5 eprop from graupner and 8 inches props also to try from an other company.

Can you help? Doesn't work when I use custom battery (ThunderPower 5400 mah 25/50 c burst 14.8v How do I find out battery's resistance? What is "P" in the battery section (next to cells) And I'm not sure how to select to good prop

So, 10 inches is too much? How can I calculate myself what is the best with what I have? Personnal experience, a calculator? Formula? Please help