Recent content by Benewake

Hey Here, We are sincerely looking for the regional agents worldwide. The agents should qualified for the following requirement: 1. We have the simiar market and it would be great if you had some potential customers in our LiDARs' main application: Benewake’s LiDAR sensors are widely applied...

Hey Here, We are sincerely looking for the regional agents worldwide. The agents should qualified for the following requirement: 1. We have the simiar market and it would be great if you had some potential customers in our LiDARs' main application: Benewake’s LiDAR sensors are widely applied...

Document description The barometer, as the main sensor component of flight control altitude measurement at present, meets the needs of fixed altitude in most cases, but its accuracy is not satisfactory, especially in advanced flight, such as automatic takeoff and landing, which is difficult to...

1. Auto-measuring Instrument for Body Flexion 1.1 Application Background Sit and reach (as shown in Figure 1.1) is a physical exercise program and a physical fitness test program for Chinese primary and secondary schools. Its purpose is to measure the possible range of...

1.Introduction of Traffic flow and Height Detector This plan use Benewake company’s product TFmini-Plus combined with Arduino-UNO. The usage：count flowrate and height. Equipment and wires 2.1 Equipment Benewake TFmini-Plus TFmini-Plus detail is on the TFmini-Plus Instructions on...

1. Equipment and wires 1.1 Equipment MiniQ Chassis of desk robot - Diameter of chassis：122mm - Diameter of wheel：42mm - Height of chassis：15mm - Arduino board及 Romeo controller fixed hole - Motor parameters：  N20 motor voltage：3-9V  no-load speed：13000rpm  50：1 reduction gearbox ...

1. Equipment and wires 1.1 Equipment MiniQ Chassis of desk robot - Diameter of chassis：122mm - Diameter of wheel：42mm - Height of chassis：15mm - Arduino board及 Romeo controller fixed hole - Motor parameters：  N20 motor voltage：3-9V  no-load speed：13000rpm ...

Benewake TF03 LiDAR can directly be connected with the serial port of Pixhawk. TF03 can be used in flight device for the purpose of altitude holding or obstacle avoidance. This document is suitable to Pixhawk adopts ArduCopter V3.6.2 or higher firmware(Note:Standard output mode should be used...