Recent content by Asesapie

Well I took the gimbal apart today to see if I could find something broken and found the grub screw for the yaw motor to the gimbal arm was loose. I tightened it up and the gimbal is working great. Glad it isn't broken

I tried that at least uninstalling the gimbal assistant. There isn't anything else h33d related that I can think of. I guess I can try again tomorrow.

Well I had a small mishap and my 550 ended up stuck upside down for about an hour and the gimbal continued to try to center itself again but was unable to as it was upside down. Well it was way off center after this issue so I attempted to reset the gimbal via jumping the two points on the...

I have tried adjusting the end points on my transmitter and the settings in the naza with no success. The knob continues to act as a switch which doesn't make any sense. The know moves slightly and the gimbal goes straight down.

I am using a knob not switch. I don't know why it's only going from straight forward to down. I have the graupner mx-20 transmitter and it worked great with my previous gimbal.

well I have my gimbal working now except when adjusting the tilt from my transmitter I only have straight forward or down. There is no adjustment otherwise. I've tried adjusting the movement from the transmitter and naza software and nothing changes. Any ideas why or how to get the full range of...

I'll try a different channel but the the channels it is currently plugged into are the same channels my previous gimbal were plugged into and it worked just fine. I'll try that and see what happens

So the gimbal is still glitching. Any ideas why this happens when the transmitter is turned on?

So as the title says my gimbal glitches out when my TX is turned on. I believe I have all of the connections made correct from the receiver to the naza. Without the TX on the gimbal is great then I turn on the TX and it starts to glitch out. Anyone have any idea why? I'm using the Graupner...

It is wired with 12 gauge deans ultra wire. To me it has to be a bad joint and unfortunately a bad joint I didn't solder together. I'll have to see what can be done. Thanks everyone

I was carrying my normal payload just gimbal and camera. There really isn't any reason this joint should have come apart like it did. Every part on the 550 was cool and not hot like it should have been if it over amped the plug and caused it to pop like that. The solder appeared to be good but...

So I was filming the fireworks show here in a safe area where I didn't have a chance to damage anything in the event my 550 crashed. We'll I was flying about 2-3 minutes in and my 550 fell from the sky like a rock. I ran over to see the damage and the positive lead on the main EC5 plug came...

Okay so I have my transmitter connected to the F550 and have flown it twice. Today on the second flight it went to failsafe mode 15 seconds after flying and seems to be stuck in failsafe. I have my switch on my TX set up for the GPS and Failsafe. When I toggle the GPS switch it only highlights...

I have tried to set this thing up over and over and continue to get the error: configuration on error, this may cause by firmware upgrade from old version or abnormal TX calibration. Re-calibrate your transmitter and power cycle your controller and check all of the parameters." i have aver...

Thanks Tahoe Ed. I found there are three different ways to set up the receiver for a plane. I have a pic below showing how to wire the receiver for the different types of airplanes. Do you know what places on the naza the wires from the receiver would go? I really appreciate the assistance so far.