DJI F450 Naza + Turngy 9x HELP

H

harry2509

Member
Hey,

Running Naza with Turnigy 9X + 9X8C Receiver, all ESC's and motors are from DJI.

I have all my calibrations setup, and have the following naza to receiver channels:

A - CH1
E - CH2
R - CH3
R - CH4
U - CH5
X1 - CH6
X2 - CH7
X3 - NULL

I cannot get my motors to start and I cannot setup the failsafe. I have looked at other tutorials but no use as they all have different setups, so please no links to other threads or videos etc.. I just need a tutorial to setup everything on the receiver and software to get going!

Hep would be very appreciated,

Harry
 

W

windzer

New Member
harry2509 said:
Hey,

Running Naza with Turnigy 9X + 9X8C Receiver, all ESC's and motors are from DJI.

I have all my calibrations setup, and have the following naza to receiver channels:

A - CH1
E - CH2
R - CH3
R - CH4
U - CH5
X1 - CH6
X2 - CH7
X3 - NULL

I cannot get my motors to start and I cannot setup the failsafe. I have looked at other tutorials but no use as they all have different setups, so please no links to other threads or videos etc.. I just need a tutorial to setup everything on the receiver and software to get going!

Hep would be very appreciated,

Harry
Click to expand...
you just whant somebody to do it for you right first off channel 3 is t what software are you looking for Naza Assistant Software ?http://www.dji-innovations.com/products/naza-multi-rotor/downloads/ ..ER9X NAZA setup on x copter ch1 100%ail, ch2 100%ele, ch3 100%thr, ch4 100%rud ,ch5 76% half ID0 (for gps),+9%half ID1 (Attmode),+ -59%half ID2(manual) ch6 -73%full thr(home lock off and on)
 

H

harry2509

Member
Sorry yes CH3 is T, I don't have an ER9X and I have already calibrated everything using the dji software is it possible to write the instruction in a list form, its a little confusing otherwise.

Thanks again,
Harry
 


You must log in or register to reply here.
Top