WKM Upgrade from 5.08 to 5.14

W

worbc

Member
Folks, I'm finally getting around to updating the WKM firmware from v5.08 to v5.14. I want to make sure my current settings are not overwritten until I can get them written down, or make a backup copy that can be imported after the update. I don't have the earlier Wookong-M Assistant Software that will allow me to access the current setup, when I install 5.14, it insists that I update 5.14 however there appears to be no way I can get to the current settings. I tried to find 5.08 and it appears to not be available I've searched the forums looking for any suggestions, but none. Is there anyone out there who has done this before that can help?

Warm regards,

--terry
 


Tomstoy2

Tomstoy2

Member
Your old settings WILL be in the new 5.14, so you can write them down.
Remember, with each page, even though your settings are there you MUST default and then enter in the setting you wrote down. You can not just hit write.
Also, remember you MUST redo the transmitter calibration and also the compass calibration.

I just did this yesterday and everything went really well.
 

You must log in or register to reply here.
Top