Just noticed something... not sure if it is a bug or intentional (I doubt it).... if failsafe in on... you cannot program (write) gain %. It gets all screwed up and may or may not revert to new or old setting while turning off faisafe (if programmed during failsafe). Must turn failsafe off in order for gain programming (write) to work property. This is for assistant 1.30a on 5.12a firmware. Not sure if other assistant or firmware have this issue. See below video for details.
I'm also not using X3 for RTH but using switch programmed to drop into failsafe on Futaba TX.
Ken
I'm also not using X3 for RTH but using switch programmed to drop into failsafe on Futaba TX.
Ken
Last edited by a moderator: