A2 ppm frsky

[kiliam]

Hi guys

The title says it all, i get an RX Error in a2 assistant with frsky with ppm.
Dont want to fly like this so i tested my new s800 with a dt7 from a f450, just a light hover.
Really wanted to start testing the s800, i already got the arris gimbal for a nex camera to test in it too.
Thanks for any help.

 

[FJJ]

I have my FrSky Rx set as D-Bus in Naza and it works perfectly - have you tried that?

 

[Jumpy07]

I am also using SBUS from FrSky to A2.. 16 channels... using X8R.. Sbus to A2 and PWM to Zenmuse Gimbal.. bound in D16 mode..

 

[rilot]

Same as Jumpy. X8R with D-Bus.

 

[kiliam]

Thanks guys, my best bet is the x8r. My tx module is djt so with the x8r i will only have 8 channels.
The A2 must have some bugs, with ppm all channels are working, but there is a warning message in dji assistant complaining and i am scared to fly like this with an s800.
This is a 2 men setup so we will be using another rx and tx for gimbal.

 

[Jumpy07]

FrSky had a lot of issues in early firmware with PPM, there was not enough in the timing when all channels were maxed.. much safer to use SBUS.

I use Taranis.. single X8R with all 16 channels for single operator, its very easy to swap over to dual operator though..