danielburns
New Member
We use an Aeronavics Skyjib Super 6 Ti-QR with both a Canon 5D Mark III and a Panasonic GH3 with associated Zenmuse mounts.
For the past couple of weeks we've been trying to get results from the Photogrammetry Tool in the DJI Ground Station software and we've been struggling. We have successfully flown with and got some results back using this method, however our main sticking point is that there is often a mismatch between the number of photos the camera takes and the number of GPS co-ordinate entries extracted from the iOSD. On the rare occasion the data and number of photos match but it is more often than not the case where we get a discrepancy between the two. Both cameras seem to have the same issue but are triggered differently when attached to the Zenmuse, one via infrared and one by a dedicated remote cable.
I have tried numerous combinations of figures in the GP Servo Action window and nothing seems to make any difference.
If anyone has had similar problems or if anyone has any input on this it would be great to hear from you.
Regards,
Dan
For the past couple of weeks we've been trying to get results from the Photogrammetry Tool in the DJI Ground Station software and we've been struggling. We have successfully flown with and got some results back using this method, however our main sticking point is that there is often a mismatch between the number of photos the camera takes and the number of GPS co-ordinate entries extracted from the iOSD. On the rare occasion the data and number of photos match but it is more often than not the case where we get a discrepancy between the two. Both cameras seem to have the same issue but are triggered differently when attached to the Zenmuse, one via infrared and one by a dedicated remote cable.
I have tried numerous combinations of figures in the GP Servo Action window and nothing seems to make any difference.
If anyone has had similar problems or if anyone has any input on this it would be great to hear from you.
Regards,
Dan