Flydigital
Member
I've set up my H3-2D gimbal. connected to NAZA and all working fine except the dial - P1 isn't calibrated very well.
If I move the pot through it's full sweep the movement of the gimbal occurs between about 15-50%
I've done the X1 calibration on the PC but don;t know what more settings there are to play with.
On the PC set up there is a Gimbal section with various settings. Any changes here don't reflect any change on the system. Also turning Gimbal section on or off on PC doesn't affect the gimbal either - it still moves using P1 whether it's on or off.
It's usable but would be much better if I knew how to refine this. Thanks for any help here folks!...
If I move the pot through it's full sweep the movement of the gimbal occurs between about 15-50%
I've done the X1 calibration on the PC but don;t know what more settings there are to play with.
On the PC set up there is a Gimbal section with various settings. Any changes here don't reflect any change on the system. Also turning Gimbal section on or off on PC doesn't affect the gimbal either - it still moves using P1 whether it's on or off.
It's usable but would be much better if I knew how to refine this. Thanks for any help here folks!...