ross_badger
Member
For sale is a lightly used AutoQuad 6 flight control board and everything needed to fly any type of multirotor. I've used this board successfully on one of my hexacopters this past fall and it works very well. It has never been crashed and has been fully protected at all times. I'm downsizing so this board has to go. Everything here is well over $500 if purchased new.
The price is $340 which includes USPS Priority shipping to the US, and includes the following:
1) AutoQuad 6 board, fully assembled latest Rev 2
2) GPS groundplane shield assembled for AQ6
3) USB to Serial adapter for wired programming
4) Bluetooth serial adapter for wireless programming
5) 8GB micro memory card
AQ6 Board Specifications:
- 9-axis onboard analog IMU and GPS module
- 2" x 2.5" main board with MK mounting hole pattern
- Input voltage: 6.5V => 18v
- High efficiency DC/DC converters
- STM32F407 32bit Cortex M4 microcontroller @ 168Mhz (1MB flash)
- Standard Arm 10 pin 0.05" pitch SWD connector footprint
- 14 general purpose PWM controllers / receivers (powered or un-powered @ 5V/1A)
- Dedicated Spektrum satellite (remote receiver) 2.4Ghz R/C radio connector
- uSD card slot driven by 4bit SDIO capable of 100Mb/s transfer (up to 32GB storage)
- onboard uBlox LEA-6T precision timing GPS module with battery backup and timepulse capture
- onboard u.fl (Ipex) active GPS antenna connector
- optional external bi-directional telemetry radio (Xbee, Bluetooth, 433/868) via standard 6 pin FTDI connector - powered up to 1A
- I2C bus connector for I2C ESC's (or other I2C devices)
- Onboard 9 DOF analog sensors (3x RATE, 3x ACC, 3x MAG) w/EMI hardening
- Battery voltage monitor
Please PM me if you are interested or have any questions.
The price is $340 which includes USPS Priority shipping to the US, and includes the following:
1) AutoQuad 6 board, fully assembled latest Rev 2
2) GPS groundplane shield assembled for AQ6
3) USB to Serial adapter for wired programming
4) Bluetooth serial adapter for wireless programming
5) 8GB micro memory card
AQ6 Board Specifications:
- 9-axis onboard analog IMU and GPS module
- 2" x 2.5" main board with MK mounting hole pattern
- Input voltage: 6.5V => 18v
- High efficiency DC/DC converters
- STM32F407 32bit Cortex M4 microcontroller @ 168Mhz (1MB flash)
- Standard Arm 10 pin 0.05" pitch SWD connector footprint
- 14 general purpose PWM controllers / receivers (powered or un-powered @ 5V/1A)
- Dedicated Spektrum satellite (remote receiver) 2.4Ghz R/C radio connector
- uSD card slot driven by 4bit SDIO capable of 100Mb/s transfer (up to 32GB storage)
- onboard uBlox LEA-6T precision timing GPS module with battery backup and timepulse capture
- onboard u.fl (Ipex) active GPS antenna connector
- optional external bi-directional telemetry radio (Xbee, Bluetooth, 433/868) via standard 6 pin FTDI connector - powered up to 1A
- I2C bus connector for I2C ESC's (or other I2C devices)
- Onboard 9 DOF analog sensors (3x RATE, 3x ACC, 3x MAG) w/EMI hardening
- Battery voltage monitor
Please PM me if you are interested or have any questions.
