A2 Flight Control with Futaba 8FG Super

M

Matto822

Member
Little problem here I have linked my 8fg super to the A2 and everything shows up on the assistant software but when it comes to the controls the only thing working is the letf and right sticks, there are no responses from any other channel. I know its something small probably but I have been messing with it for hours. Is there a setting in the remote or something i have to change in order to see my other channels. When I go to channel mapping and flip all my switches nothing works but the sticks. I can start and stop the helicopter fine but I need to start mapping out my switches and I cannot. Please help. I have the newest 2.1 asst software also and my remote is in Mult mode. I have also tried MLT2 and Chl 7 no luck.
 

T

Tahoe Ed

Active Member
I use MLT2. You have to assign the channels in in your tx and then map them in Assistant. I have a 8FGS as well and I have been able to map 9 channels so far. I am loping for the last three to control the Z15 for single operator.
 


T

Tahoe Ed

Active Member
Matto, it is. I actually just checked an I now have 12 channels mapped in the Tx and the same in Assistant.
 

You must log in or register to reply here.
Top