SkyJib Super-6 Ti-QR Build Thread

[cbpagent72]

Hey Guys I have started to build my SkyJib Super 6 Ti-QR with a Zenmuse GH3 gimbal. The following are a list of my parts:

T-Motor MN4014 330KV
T-Motor 17" Carbon Props
DJI Wookong M with V2 IMU
DJI OSD II
DJI Bluetooth LED
DJI 900 MHz datalink
DJI 5.8 GHz video downlink
Maytech 45amp ESC w/Simon K Flash
Futaba 14SG radio
Futaba R7008SB
Gryphon Hexa PDB
RC-Lights navigation LED system
4X 8000mAH MaxAmps Batteries

View attachment 14190View attachment 14191View attachment 14192View attachment 14193

 

[cbpagent72]

View attachment 14194View attachment 14195View attachment 14196View attachment 14197View attachment 14198

 

[cbpagent72]

View attachment 14199View attachment 14200View attachment 14201View attachment 14202

 

[cbpagent72]

View attachment 14203View attachment 14204View attachment 14205

 

[rotorvista]

looking good should be flying the weekend

 

[rotorvista]

just noticed you've got 17" props, do you mean 15" cos 17" won't fit on a SJ6 it is 17" from motor to motor

 

[cbpagent72]

just noticed you've got 17" props, do you mean 15" cos 17" won't fit on a SJ6 it is 17" from motor to motor

No, I mean 17". That is the recommended prop size for those motors on the Skyjib super 6. Droidworx stated that they are getting awesome flight times out of that setup. The bombs are longer than the standard skyjib 6.

Sent from my SPH-L720 using Tapatalk 2

 

[cbpagent72]

Sent from my SPH-L720 using Tapatalk 2

 

[rotorvista]

blimey they swap and change their specs like the weather, yes you're right the SJ6 has now got longer booms overall 1080mm my SJ6 is 920mm, be good to see what how yours compares. i never got those nice prop bags either it's going to be a nice bird

 

[cbpagent72]

Tonight I soldered 12 extension cables with 3.5mm bullet connectors. I needed a bit more length from my speed controller to my PCB. I stepped back and looked at my project and I have no idea where to put the rest of the electronics and still be able to put the dome on. The gel adhesive below the IMU really didn't give me a lot of room on the height, I had to leave off the Gryphon BEC plate otherwise the crash cage wouldn't fit.

View attachment 14222View attachment 14223View attachment 14224View attachment 14225

 

[cbpagent72]

My next step is installing the boom nacelles, anyone on here have any tips for me before I install them?

View attachment 14226

 

[rotorvista]

here's my stack using the Droidworx PDB View attachment 14227 View attachment 14228

 

[cbpagent72]

here's my stack using the Droidworx PDB View attachment 17895 View attachment 17896

Thanks for sharing, that looks really clean. I just don't have that kind of space since I used the Gryphon PCB.

I see you are using EC5 battery connectors as well.

Sent from my SPH-L720 using Tapatalk 2

 

[cbpagent72]

Well I got the Nacelles put on this weekend and I am really liking the look. Next step to put in the electrical parts such as Wookong and receiverView attachment 14288View attachment 14289View attachment 14290 and tidy up wires.