MultiWii / NAZE / SP Racing F3 RTH failsafe

[doehme]

Hi All,

What needs to be configured to get MultiWii to acivate RTH mode in the event of lost radio control signal or is this feature active by default? I'm using the HK MW Pro w/GPS.

Yours,

Dene

 

[JohanRC]

I don't think it is possible yet.
But one option is that you use the fail safe option of the receiver and set the receiver for RTH when the signal is lost.

Greetz Johan

Sent from my Nexus 4 using Tapatalk

 

[DucktileMedia]

It wouldnt matter what controller you have, the trigger for loss of signal is always in the fail-safe side of the radio. As long as you have a fail safe switch option, you can normally setup any combination of switch or stick positions in fail safe. keep in mind (at least on JR)there are 2 different methods of binding. One binds the tx to the rx, the other sets the current modes on the radio as the fail safe.