DJI A2 Fail Safe - testing on the bench

roryhinds

roryhinds

Member
So I've set my FailSafe on my Futaba T14 and everything seems to work in the A2 Assistant Software.

But when I turn the T14 off to test if the FailSafe will kick in from lost of signal from the transmitter it doesn't go into FailSafe on the A2 software.

This doesn't seem right.
How do you get it to go into FailSafe when transmitter is off or lost signal?
 

Kilby

Kilby

Active Member
Do you have to program that with the RX? I know I had to once before, but it's been ages. Check your Futaba manual about programming failsafe.
 

T

Tahoe Ed

Active Member
The A2 is different. Page 16 of the v1.08 manual out lines the way it is supposed to work. If that is not happening, then you have a set up issue. I would also recommend that you upgrade you firmware.
 

Q

Quinton

Active Member
roryhinds said:
So I've set my FailSafe on my Futaba T14 and everything seems to work in the A2 Assistant Software.

But when I turn the T14 off to test if the FailSafe will kick in from lost of signal from the transmitter it doesn't go into FailSafe on the A2 software.

This doesn't seem right.
How do you get it to go into FailSafe when transmitter is off or lost signal?
Click to expand...

Not sure how everything works on the A2 but this video helped me a lot to set up failsafe properly.

http://youtu.be/SmDehc5PEUQ
 

You must log in or register to reply here.
Top