Issue with hoverfly gimbal and tinysnapper

Status
Not open for further replies.
J

JB2013

Member
Hello,

I have a Dji f550 with Aeroxcraft VTR125 gimbal controlled by HoverflyGimbal. A Tinysnapper shutters the sony NEX 5N.
I connected Hoverfly and tinysnapper to the receiver (futaba r6014 hs) and now i have a problem: they only work separatly!

- Assigned Pitch control on channel 9 > VrB knob - transmitter futaba 10C
- Assigned tinysnapper on channel 10 > Switch H - transmitter futaba 10C

if i connect only pitch controll on channel 9, i am able to control gimbal pitch through VrB knob.
If i connect only tinnysnapper on channel 10, i am able to shutter the camera.
if i connect both, the camera shutter doesnt work! But if i disconnect pitch control on ch. 9, then the camera shutter starts to work.

I cant find any solution for this and i need some help from the experts. ;)
Thanks a LOT in advance.
 



J

JB2013

Member
Well, solved the problem. So simple!I simply disconnected the red and black wire of the Hoverfly servo cable. Now it works! :)
 

Status
Not open for further replies.
Top