Hi Everyone
I am near at my wits end. I have finished building a Hexa plus copter, my control board is a Crius AIOP. I have assembled it. and double and triple checked all wireing etc, however, as soon as I activate the throttle the motors start up and just get faster and faster, when it begins to take off it wobbles left and right and crashes badly, I have tried holding it over my head to test it while it is running but it does the same thing, throws itself all over the place. I have made sure the frame is secure, calibrated the board and correctly leveled it, all motors are attached firmly to the aluminium arms and they do not seem to have much vibration. I really need help I dont know what to try or how to trouble shoot from here. everything seems fine in the Megapirate mission planner (Gyro, Baro, Accel, Compass). Any Ideas?
Here is my list of parts:
D2830-11 1000kv Brushless Motor X 6
Turnigy Multistar 30 Amp Multi-rotor Brushless ESC 2-4S (OPTO) X 6
ZIPPY Flightmax 5000mAh 3S1P 25C X 1
Turnigy 9X 9Ch Transmitter w/ Module & 8ch Receiver (Mode 1) (v2 Firmware)
CRIUS AIOP v2.0 X1
UBEC X 1
Also I have programmed all ESCs, reloaded Megapirate to the board.
I am near at my wits end. I have finished building a Hexa plus copter, my control board is a Crius AIOP. I have assembled it. and double and triple checked all wireing etc, however, as soon as I activate the throttle the motors start up and just get faster and faster, when it begins to take off it wobbles left and right and crashes badly, I have tried holding it over my head to test it while it is running but it does the same thing, throws itself all over the place. I have made sure the frame is secure, calibrated the board and correctly leveled it, all motors are attached firmly to the aluminium arms and they do not seem to have much vibration. I really need help I dont know what to try or how to trouble shoot from here. everything seems fine in the Megapirate mission planner (Gyro, Baro, Accel, Compass). Any Ideas?
Here is my list of parts:
D2830-11 1000kv Brushless Motor X 6
Turnigy Multistar 30 Amp Multi-rotor Brushless ESC 2-4S (OPTO) X 6
ZIPPY Flightmax 5000mAh 3S1P 25C X 1
Turnigy 9X 9Ch Transmitter w/ Module & 8ch Receiver (Mode 1) (v2 Firmware)
CRIUS AIOP v2.0 X1
UBEC X 1
Also I have programmed all ESCs, reloaded Megapirate to the board.