workshop
Member
This was proof of concept and prototype I designed for the American Pickers television show. Video from this T6 multicopter can be seen Mondays on the History Channel.
For sale is a COMPLETE bind and fly system including batteries and a custom, direct drive roll/tilt gimbal designed and built especially for this copter using ServoCity parts and the fastest HiTec servos available. The T6 is completely setup and can be bound to the EzUHF transmitter or you can replace the 8 channel receiver with one of your choosing. The custom T6 frame uses standard Rusty’s pinch blocks and hole spacing for 5/8” (16mm) booms so replacement parts are easy to obtain. The FPV system includes a cable for the GoPro 2. Switching to a GoPro 3 requires a standard housing and video cable.
The T6 can lift a 4 pound camera gimbal combo should one decide for a AV130 or AV200 and suitable camera. The oversized ESCs stay cool as do the motors. Run time is 15 minutes with time to come home and land. You get everything shown in the photos except the GoPro camera, boxed and ready to ship for $2,800.
The first video test flight can be seen here: http://www.youtube.com/watch?feature=player_detailpage&v=89jNFywE-rA
Airframe: Custom Carbon Fiber T6
FCB: HoverFly Pro/GPS
RX: EzUHF 8 Channel
Video TX: Lawmate 2.4GHz 500mW
Video RX: Lawmate 8ch.
Video Antenna: IBCrazy Cloverleaf CP
Roll&Tilt: Hitec Digital HS-7940TH
Motors: Avroto 2814
ESCs: Maytech 45A Opto
Props: 11x4.7” APC
Batteries: Two 5,000mAh, 4 Cell
Required to fly: HD Camera - GoPro 2 or 3, RC Transmitter
PM me or email at jparisse at me dot com... Thanks
For sale is a COMPLETE bind and fly system including batteries and a custom, direct drive roll/tilt gimbal designed and built especially for this copter using ServoCity parts and the fastest HiTec servos available. The T6 is completely setup and can be bound to the EzUHF transmitter or you can replace the 8 channel receiver with one of your choosing. The custom T6 frame uses standard Rusty’s pinch blocks and hole spacing for 5/8” (16mm) booms so replacement parts are easy to obtain. The FPV system includes a cable for the GoPro 2. Switching to a GoPro 3 requires a standard housing and video cable.
The T6 can lift a 4 pound camera gimbal combo should one decide for a AV130 or AV200 and suitable camera. The oversized ESCs stay cool as do the motors. Run time is 15 minutes with time to come home and land. You get everything shown in the photos except the GoPro camera, boxed and ready to ship for $2,800.
The first video test flight can be seen here: http://www.youtube.com/watch?feature=player_detailpage&v=89jNFywE-rA
Airframe: Custom Carbon Fiber T6
FCB: HoverFly Pro/GPS
RX: EzUHF 8 Channel
Video TX: Lawmate 2.4GHz 500mW
Video RX: Lawmate 8ch.
Video Antenna: IBCrazy Cloverleaf CP
Roll&Tilt: Hitec Digital HS-7940TH
Motors: Avroto 2814
ESCs: Maytech 45A Opto
Props: 11x4.7” APC
Batteries: Two 5,000mAh, 4 Cell
Required to fly: HD Camera - GoPro 2 or 3, RC Transmitter
PM me or email at jparisse at me dot com... Thanks
Attachments
Last edited by a moderator: