roryhinds
Member
Anyone out there with more knowledge of the Wookong M's Voltage Monitor and Heavy Lifting SkyJib 8?
I have a SkyJib 8 with
AXI 2826/12 motors
65Amp ESC's
15x4 Carbon Fibre Props
2 x 12000mah 5S 100C constant batteries
I'm seeing only 4 minutes flight time with my full load (total weight 12kgs with AV200 + Red Epic) and I think I have my Voltage protector settings not quite right.
When I landed after 4 minutes I still have 47% left on the batteries so wonder why the Wookong made me land and I wonder if I can adjust the settings to get another 2 minutes flying time and still be safe.
My cut off was set to 18V.
Is it safe to set this to a lower figure and use more % of the batteries.
I'd like to get it that I'm landing and on the ground and have 20% left in the batteries. (Yes I'll come home before that time for sure)
The AXI 2826/12 motors are rated to used 3S - 5S so thats 11.1v to 18.5V
Would I be safe to run my 5S batteries to 17V which would be 3.4v per cell?
What are others doing with Heavy Lifting and flying a UAV of 12kg's (26.5lb)
I have a SkyJib 8 with
AXI 2826/12 motors
65Amp ESC's
15x4 Carbon Fibre Props
2 x 12000mah 5S 100C constant batteries
I'm seeing only 4 minutes flight time with my full load (total weight 12kgs with AV200 + Red Epic) and I think I have my Voltage protector settings not quite right.
When I landed after 4 minutes I still have 47% left on the batteries so wonder why the Wookong made me land and I wonder if I can adjust the settings to get another 2 minutes flying time and still be safe.
My cut off was set to 18V.
Is it safe to set this to a lower figure and use more % of the batteries.
I'd like to get it that I'm landing and on the ground and have 20% left in the batteries. (Yes I'll come home before that time for sure)
The AXI 2826/12 motors are rated to used 3S - 5S so thats 11.1v to 18.5V
Would I be safe to run my 5S batteries to 17V which would be 3.4v per cell?
What are others doing with Heavy Lifting and flying a UAV of 12kg's (26.5lb)